“AQUANIT”
 |
|
 |
Waterproofing dry construction mix manufactured by “Sarmat” construction holding company is used for different mineral substrates.
ÃÑ-11 STB [National Standards System of the Republic of Belarus] 1072-97 |
|
|
The properties of the ready-to-use mix:
|
“AQUANIT” has enhanced adhesive properties. It is very elastic, frost-resistant and easy-to-use. |
|
Preparation method:
The waterproofing is gradually added to pure water and is mixed thoroughly with a low-speed drill until obtaining lump free consistency. Stir the mix again in approximately 10 minutes. Now it is ready for use. The prepared mix preserves its properties within 1.5 hours.
Method of application:
2-3 layers of the mix are applied athwart. The period between application of each layer is 24 hours. Make sure the surface is smooth. Use a brush or a filling knife applying the mix on the smooth surface. Prevent covered surfaces from drying too quickly, from the influence of direct sunlight, drought and low humidity. The temperature of preparation and application shall be +5 °Ñ … +25 °Ñ.
Technical Specifications:
| Water consumptions when spreading the mix with a brush: |
8.0 – 8.5 liter of water
per 25kg of the mix |
| Water consumption when spreading the mix with a filling knife: |
6.0 – 6.5 liter of water
per 25kg of the mix |
| Application temperature : |
+5°Ñ / +25°Ñ |
| Pot life |
1.5 hours |
| Consumption of dry mix per 1mm of layer thickness |
1,8 kg/m2 |
| Recommended layer thickness |
1.0-1.5 mm |
| Adhesion to the concrete surface |
>1,2 MPa |
| Water impermeability |
0,5 MPa |
| Frost resistance |
75 cycles |
| Storage period |
6 months |
|
|
You can ask a question about the use of “Sarmat” dry mixes here. |
|
|
